![]() ![]() Perform a loopback test: Type any character.If the device will support it, make a Telnet or proxy connection to the near-end device.Take a paper clip or screwdriver and loop the port's TX pin (typically Pin 2 on RS-232 ports) to its RX pin (typically Pin 3 on RS-232 ports). Remove the cable from the near-end port of the problem connection.With that established, you can move on to testing cables, protocols, and other equipment in your system. Shorting pins can confirm that your device and its data port are working properly. In our work with remote monitoring and control systems, DPS Tech Support reps frequently help our clients use loopback testing to troubleshoot RTUs that aren't reporting alarms correctly. When you're setting up any kind of communication serial device, you'll probably have to troubleshoot data ports activity at some point. Loopback is a good RS-232 check tester method. Use a screwdriver to loop pins for testing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |